Bilge pump controller (auto and manual)

From uCtrl
This page is kept for historical interest. It may document projects or methods that are obsolete and/or no longer relevant. The information here is not kept up-to-date.

I made this module for my dad's boat back in 2006. That boat was sold many years ago.
Pump control

Information

This is a very simple pump control unit, for boats with a water level sensor. Two modes can be selected:

  • Auto; the pump start automatically on signal from the water level sensor.
  • Manual; overriding the sensor, forcing the pump to run.

The unit can three LEDs:

  • Green; auto mode has been selected.
  • Yellow; the pump is running.
  • Red; signal from water level sensor is active.

The relay, and fuse, is 10 A.

Images

Schematic drawing

Boat-pump-controller-circuit-q0yk54.png

Parts list

Qty. Part
2 Diode, rectifier, 1 A, 400V, 1N4004
1 Enclosure, plastic (1591 FL), 100x50x25mm, flange
1 Fuse holder, panel, 5x20mm, PTF30
1 LED 3mm, Green, 2.1V, 20mA, 3.5mcd, 38°
1 LED 3mm, Red, 2.1V, 20mA, 1.0mcd, 38°
1 LED 3mm, Yellow, 2.0V, 20mA, 2.5mcd, 38°
3 LED holder 3mm, Chromed metal
1 Relay, 1 CO, G2R-1, 12 VDC, 10A 230V
1 Relay, 2 CO, HJR1-2C, 12 VDC, 1A 120V, PCB
3 Resistor, metal film, 0.6W, 1 kΩ, 1%
1 Switch, toggle, 1-pole, micro, on-(on)
1 Switch, toggle, 1-pole, micro, on-on